1/14 and 1/18th Suspension Setup Station Kit

ab 0,52 €

inkl. MwSt., zzgl. Versand

Beschreibung

Varianten

  • Variante 1: setup kit Camber panel left
  • Variante 2: setup kit Camber panel right
  • Variante 3: setup kit Camber upright
  • Variante 4: setup kit axle nut
  • Variante 5: setup kit toe bar V2

Beschreibung

Die originale Beschreibung des Autors

This is a suspension setup kit modeled after the higher end ones used for 1/10th and 1/8th racing but scaled down to use for 1/14 and 1/18th scale RC cars. This kit will need 8x 2x5x2 or 2x5x2.5mm ball bearings, 10x m2 10mm screws, and a way for you to paint or mark the tick marks on the models if you aren't using multi color printing. the hex pattern in the sides of the camber panels are sized for the Mini T but you could easily use with a larger hex by flipping the sides and using the flat side of each panel against a wheel hex. The wheel nuts are also sized for the mini T 2.0 using an M3 tappable hole in the center. These could easily be quickly drilled out and threaded/tapped for a 4mm screw if desired for another vehicle. If printed correctly it's a reasonably accurate and more reliable method than the wheel gauge type setup tools.

Mehr Informationen zum Modell und dem Einsatzzweck gibt es eventuell auf der Projektseite selbst: www.thingiverse.com/thing:4120673

Material/Farbe

Mehr Informationen zur Materialauswahl, Materialeigenschaften und den vorhandenen Farben: Druckservice > Farben

Ist eine gewünschte Kombination nicht als Auswahlmöglichkeit vorhanden? Wir nehmen Wünsche gerne entgegen und fügen diese zur Auswahl hinzu: Kontaktformular

Lizenz

Dieses Modell stammt von Thingiverse und wurde dort unter folgender Lizenz veröffentlicht:
1/14 and 1/18th Suspension Setup Station Kit by PBARSAMIAN
www.thingiverse.com/thing:4120673
Creative Commons - Attribution

Lieferumfang

Die Bestellung umfasst die auf den (meistens ersten 3) Bildern abgebildeten orangenen Kunststoffteile in der gewählten Farbe und Material.
Der Lieferumfang an Teilen kann bei Modellen mit mehreren Varianten je nach gewählter Variante abweichen und ist auf den Bildern immer passend zur aktuell gewählten Variante abgebildet.
Eventuelle weitere abgebildete Dinge wie Platinen, Schrauben, Geräte etc. sind nicht im Lieferumfang enthalten und dienen lediglich zur Demonstration des Einsatzzwecks.

Zusätzliche Produktinformationen

Material
PLA