anti walk sfx100 actuator anchors
ab 19,03 €
Beschreibung
Varianten
- Variante 1: sfx shaft anchor closed version
- Variante 2: sfx shaft anchor open version
Beschreibung
Die originale Beschreibung des Autors
please read.....printed with pla, use whatever you like
with PLA print infill with minimum of 50%. any less and you risk crushing the print when tightening the bolts to the static profile frame.
these are not intended to to be tightened extremely tight, just enough where they will not shift. the free play will minimize any lateral forces to prevent them from shifting
print walls minimum of 3mm, this will aid the washer from deforming the slotted edges when tightening.
their are two version, closed and open
the close version is needed if you dont have a sturdy frame and may be susceptible to flex, or need a bit more surface area. for the actuators shaft to move around.
the open version does not have a bottom and the shaft will go through the anchor hole and rest on the frame.
both version have slotted holes so that it can be adjusted to sit directly under the actuator shaft
the rubber legs can be purchased at any hardware store.
they are suppose to fit loosely on the shaft.
the upper portion of the anchor also has some play. this is to allow the actuator some freeplay to move both within the leg holder and the anchor hole. this is to minimize stress on the anchors, and also prevent the actuators from shifting them.
parts needed,
16 m8 x25mm bolts
16 m8 washers
16 m8 tnuts
4 rubber legs size 1 and 1/4 inch
enjoy
Mehr Informationen zum Modell und dem Einsatzzweck gibt es eventuell auf der Projektseite selbst: www.thingiverse.com/thing:4958590
Material/Farbe
Mehr Informationen zur Materialauswahl, Materialeigenschaften und den vorhandenen Farben: Druckservice > Farben
Ist eine gewünschte Kombination nicht als Auswahlmöglichkeit vorhanden? Wir nehmen Wünsche gerne entgegen und fügen diese zur Auswahl hinzu: Kontaktformular
Lizenz
Dieses Modell stammt von Thingiverse und wurde dort unter folgender Lizenz veröffentlicht:
anti walk sfx100 actuator anchors by clos2727
www.thingiverse.com/thing:4958590
Creative Commons - Attribution
Lieferumfang
Die Bestellung umfasst die auf den (meistens ersten 3) Bildern abgebildeten orangenen Kunststoffteile in der gewählten Farbe und Material.
Der Lieferumfang an Teilen kann bei Modellen mit mehreren Varianten je nach gewählter Variante abweichen und ist auf den Bildern immer passend zur aktuell gewählten Variante abgebildet.
Eventuelle weitere abgebildete Dinge wie Platinen, Schrauben, Geräte etc. sind nicht im Lieferumfang enthalten und dienen lediglich zur Demonstration des Einsatzzwecks.
Zusätzliche Produktinformationen
- Material
- PLA