KSGER T12 OLED controller soldering station case
ab 81,47 €
Beschreibung
Beschreibung
Die originale Beschreibung des Autors
I bought an KSGER controller and a 24V/75W power supply to make this DIY soldering station.The PSU is a bit bit, probably I re-create the thing with a smaller PSU so the case can be made smaller (it can be made smaller with this PSU too, I just didn't want to print it again).
Print the main case upside down with support from printbed only. Other parts don't need support.
You need countersunk M3 screws to close the case and in addition to the controler/PSU you need a switch, a powerplug and a fuse holder.
OpenSCAD included, feel free to modify.
Mehr Informationen zum Modell und dem Einsatzzweck gibt es eventuell auf der Projektseite selbst: www.thingiverse.com/thing:4601875
Material/Farbe
Mehr Informationen zur Materialauswahl, Materialeigenschaften und den vorhandenen Farben: Druckservice > Farben
Ist eine gewünschte Kombination nicht als Auswahlmöglichkeit vorhanden? Wir nehmen Wünsche gerne entgegen und fügen diese zur Auswahl hinzu: Kontaktformular
Lizenz
Dieses Modell stammt von Thingiverse und wurde dort unter folgender Lizenz veröffentlicht:
KSGER T12 OLED controller soldering station case by felixna
www.thingiverse.com/thing:4601875
Creative Commons - Attribution
Lieferumfang
Die Bestellung umfasst die auf den (meistens ersten 3) Bildern abgebildeten orangenen Kunststoffteile in der gewählten Farbe und Material.
Der Lieferumfang an Teilen kann bei Modellen mit mehreren Varianten je nach gewählter Variante abweichen und ist auf den Bildern immer passend zur aktuell gewählten Variante abgebildet.
Eventuelle weitere abgebildete Dinge wie Platinen, Schrauben, Geräte etc. sind nicht im Lieferumfang enthalten und dienen lediglich zur Demonstration des Einsatzzwecks.
Zusätzliche Produktinformationen
- Material
- XT